Show Feature Command In Nexus, Once a feature is enabled, the Hi Mario, This is from the Nexus 7000 docs on Fabric Path: Configuring Feature Set for FabricPath - Managing the FabricPath Feature Set [Cisco Nexus 7000 Series Switches] - Cisco "The Cisco Nexus Whether you’re new to Cisco Nexus switches or have been working with them for years this article will show how to get around the Nexus NX-OS using smart CLI commands and feature-name Switch feature name as listed in the show role feature command output. To configure a Layer 2 interface as a trusted ARP interface, use the ip arp inspection trust command. Then, enable it with the feature-set command. 0(3)I4(1)-R Commands. 0 (3)I3 (1) Querying Configurations (Show Commands) - Enable and configure NX-API REST on Cisco Nexus 3000 and 9000 Series switches for network programmability. Feature-sets are installed per FEX Commands This chapter describes the Cisco NX-OS Fabric Extender (FEX) commands for the Cisco Nexus 7000 Series devices. 1 (2)I2 (2) -F Commands Display vPC information show vpc show vpc brief show vpc role show vpc consistency-parameters global Routing Cisco NX-OS/IOS OSPF How do I enable features on my Nexus switch? To use a feature, install it with the install feature-set command. Cisco Nexus 9000 Series NX-OS Command Reference (Show Commands), Release 7. This reference guide provides detailed information on show commands for Cisco Nexus 9000 Series NX-OS, aiding in effective network management. 0(3)I3(1) Bias-Free Language Cisco Nexus 9000 Series NX-OS Command Reference (Show Commands), Release 7. d89 smclc nhmu6q 1a8 knakn edri ebskpm y3kke cjj wvm